I'm watching your exhaust bung install. With my Muzzy headers, both headers wrap around to the right side of the bike. I think it might be easiest for me to have the bungs welded on to the left side of each header and wrap the cords across the engine, and around the left side of the bike. You think that should work or are the cords not long enough?
Other than that, your install is looking nice so far! My K&N and crank breather also got delivered the other day, and my fuel cut-off thingys and my petcock gasket also just got delivered this morning. I'm just waiting on my FI kit next week.
Where are you thinking about putting the engine block temp sensor? You can drill a little hole in the K&N and seal the air temp sensor into it with silicon, but I'm wondering about the engine temp sensor. Maybe @
EMSRacer07 should post a picture of that for us n3wbs to benefit this thread
