optional demon eyes installation instructions:
To install the demon eyes, you need to open up the projectors and glue the demon eye rings.
You need to use high temp clear silicone to glue the demon eye ring, which is available on bkmoto or your local hardware store.
Here is the demon eye ring that needs to be glued into the projector.
undo the screws on the back of the projector body
undo the screws that hold the hi/low beam motor/flap
place the ring into the projector so you know where to put the silicone glue
remove the ring and put down silicone glue
Place the ring onto the silicone and let it dry for 12 hours.
Now put together the projector.
Wiring:
The wiring of this projector set is pretty simple
We will wire for both headlights to be on for low beams and high beams using the factory handlebar switch, with the addition of a small on/off switch which will enable you to turn off the headlights and keep the halos/demons on.
here is all the wiring labeled:
1. Connect both White low beam + to Low beam + pigtail
2. Connect both Blue high beam + to high beam + pigtail
3. Connect both Halo red + to low beam + pigtail
4. Connect both Halo black - to low beam ground - pigtail
5. all other connections self explanatory.
that's it.
Here is how to wire using a simple on/off switch to turn off low beam HID's to have only halo's on, or to start the bike with hid's off to avoid stressing the battery
Thats it, now put the bike together and enjoy your new lights!