Quote:
Originally Posted by tfkrocks
So there isn't Ninja 300 specific directions yet, but I figured it would be about the same as the FI Ninja 250R directions that Scottoiler has on their site. I have no idea how to remove the vacuum tube from the throttle body. I'm not entirely sure I'm even looking at the right part honestly. Maybe it would be better to just cut the tube to do this? Really could use some guidance on this.
|
Hey, i've fitted one to my ninja 250r don't cut the tube just yet, my 250r had one vacuum tube come off the throttle body on the left side of the throttle body and a bung over the spiggot on the right hand side, I took the rubber bung off and fitted it to that.
Well, I cut the bung off with a knife as it was a pain to pull off, then fit the rubber L joint bit and you're golden.
Assuming the 300 throttle body is the same as the 250 which I doubt as it's a different system.