Quote:
Originally Posted by eulark
I think im at the point where im going to go ahead and button this thing up and get it on the bike.
So still have clutch to deal with, Valve clearances, and install. Then carbs need cleaning and I'll need to go over the electrical stuff on the frame.
Questions.
1. Pretty much every cable on the bike was loosened and or disconnected to remove the motor. I am terrible with the way these things are setup like the clutch cable. Any where i can get a better idea of how they work?
2. Carb cables, i undid them, stupid of me. Is there a walkthrough of how to set them up?
|
Congratz on getting this far. I'm pretty much at the same point. My clutch is installed, but I need to do the valves, the carbs, and I have to service my swingarm. I hope to put the motor on the frame tomorrow.
Anyway as far as the carbs, this removal vid gives you a decent enough look at it. You can skip to like 6:45.
Link to original page on YouTube.
But like he said it's fairly easy. If you need help, I can send you some pics when I mount my motor.
Question. How does the timing work for the spark plugs?