ninjette.org - View Single Post - Room for Ninja 300 clip-ons

sprinter · July 15th, 2013, 06:43 PM

I put the Woodcraft clip-ons on my 300 track bike, but they weren't low enough. Couldn't go lower because the Brembo master cylinder I put on was hitting the gauge if I lowered the bars too far. So I used a little zip-tie engineering and a hacksaw to mount the gauge deeper in the fairing bracket, and was able to lower the clip-ons down to where I wanted them. Had to trim the race bodywork a little for clearance too, as well as trimming off the metal tabs from the ouside of the fairing bracket, but the riding position is MUCH better with the lower clip-ons.

July 15th, 2013, 06:43 PM	#14
sprinter ninjette.org member Name: JJ Location: USA Join Date: Jul 2013 Motorcycle(s): 2018 Ninja 400 Race Bike (in progress...) Posts: 126	I put the Woodcraft clip-ons on my 300 track bike, but they weren't low enough. Couldn't go lower because the Brembo master cylinder I put on was hitting the gauge if I lowered the bars too far. So I used a little zip-tie engineering and a hacksaw to mount the gauge deeper in the fairing bracket, and was able to lower the clip-ons down to where I wanted them. Had to trim the race bodywork a little for clearance too, as well as trimming off the metal tabs from the ouside of the fairing bracket, but the riding position is MUCH better with the lower clip-ons.