Quote:
Originally Posted by MR2Aaron
Depends on which ones you get. The roundish ones in the first photo in this thread required a little bit of drilling, in my case. The studs for mounting them are closer together than the stock signals, so you have to drill a hole for one of them. No biggie, IMO. I also found that I needed to trim the upper edge of them to get them to fit flat against the fairing, and solder on new connectors, as they just come with bare wires. Again, no biggie.
I'd rate installing them at about a 2.5 out of 10 on the difficulty scale. It takes a little doing, but not much.
|
Doesn't sound too bad. I followed the link someone posted above and found these guys:
http://www.madhornets.com/front-indi...moke-or-clear/ . I think I'll give them a try. Thanks for the reply. Much appreciated.