Quote:
Originally Posted by kkim
drill directly in the center of the bolt (easier said than done) and use a drill bit just a little bigger than the shank (not head) of the bolt. You should be able to drill the head off w/o damaging the fairing if you are careful and go slow.
do a little at a time (drill, stop, drill, stop, etc.). Don't know how much heat from drilling it will take to melt the fairing plastic.
|
+1
__________________________________________________
Intuitive Sliders, Aftermarket pegs, Custom Paint, Seat Cowl, Tinted Screen, Aftermarket flush mounts, Wheel Tape, Fender Chopped, Stock Shortie Exhaust and Woodcraft ClipOns
|