OK guys and girls, i managed to find a piece of scrap the size i needed. I didnt want to wait until next week to prototype this and good thing. Here it is
We start with my prototype to get my dimensions close
Onto the design now
And heres the part -
But there is a flaw, as usual with a first piece. Looks like i need to rotate the position of the bottom bolt back a little. It was biting too far down on the rotor, so ill bring it back a little. Easy change. It clears the caliper and all the holes line up. I feel the thickness is good too, it looked pretty centered to me. Now ill cut a few next week and ill send one out to you Rebecca to see how the 300 fit is.