ninjette.org - View Single Post - DIY Install of the Bikemonkey Integrated LED tail light

muloh · August 14th, 2009, 07:20 PM

I received this unit from Carl this week and finally got it installed a couple days ago. I am very impressed with this product! No cuts to any of the parts (either on my bike or the light). I plugged the turn signals into the stock connectors and heat-shrunk them to stay waterproof/tight.

Carl was kind enough to include a flasher relay that was plug and play - no cutting like in the DIY. The only part that was "difficult" was getting the socket into the stock wiring harness - it was a little sharp and I did it after putting the tail back together, so I didn't have much room. But, that's hardly anything to complain about - the quality is awesome!

August 14th, 2009, 07:20 PM	#45
muloh ninjette.org newbie Name: Brock Location: Fargo, ND Join Date: Aug 2009 Motorcycle(s): 2008 Ninja 250R Posts: 1	I received this unit from Carl this week and finally got it installed a couple days ago. I am very impressed with this product! No cuts to any of the parts (either on my bike or the light). I plugged the turn signals into the stock connectors and heat-shrunk them to stay waterproof/tight. Carl was kind enough to include a flasher relay that was plug and play - no cutting like in the DIY. The only part that was "difficult" was getting the socket into the stock wiring harness - it was a little sharp and I did it after putting the tail back together, so I didn't have much room. But, that's hardly anything to complain about - the quality is awesome!