As requested by @
BlownWideOpen, i posted these three pics. The first one shows how i wired it through the fork, then the second one shows where i attached it, which is right by the disk one the fork at the bottom. The third one is there just to show at which angle of the tire i attached it on, so in this case it was the front left side of the fork from a riding position. You can put it however you like as long as it is close enough to the magnets on the disk to where it will pick the signal up.
If you press the middle picture you will see how close it is to the allen head on the disk, which is where i put the magnet. Technically right infront of it for the most accurate reading.