wow, the temperature warmed up.. a lot! Got into the valves yesterday to check clearance. Everything was pretty close to spec... which is good news. I was not sure if this bike had ever had valves serviced before but it looks like it has. Maybe the first owner actually cared. I have to say that the 500 is easier to adjust than the 250. No shims. Also, on a side note, it is actually made in Japan. Not that I ever had an issue with the 250 coming from Thailand. Is the 250 motor made in Japan with final assembly in Thailand?
did I mention that I miss my garage. This shed is too damn small
Next, carbs...