Np, after looking closer at your picture, that left bar is most definitely bent big time, the right one as well, but just a little bit compared to the left one.
To be sure take a straight edge, a ruler will do, hold it on top, line it up with the center of the bar up by the riser, then look at it, it should line up with the center of the grip, and bar end.
The picture I posted shows where they bent at, close to the riser, this is just the design of the bars themselves, and almost always bent at the point.
__________________________________________________
violente et ignorantia
ZX-2R BLOG
Twitter and Instagram = Ghostt_Scott
I'm not here to change your mind, just to inform.
|