February 15th, 2015, 07:27 PM
|
#22
|
ironcitybikes
Name: Bob
Location: pittsburgh
Join Date: Jan 2015
Motorcycle(s): 07 ninja 250
Posts: 44
|
seem to be able to login just fine i'm sure i was doin something wrong. I got a few friends helping me do this thing up nice! So today we got to test fit a pair of setback plates that were hot off the press. Well actually the 3d printer. If there is any interest in these well make them available, most likely in 1/2 in aluminum plates. It was nice to have the kit to help wire up the lights. I can do the wiring but it would have taken a lot longer on my own! here's some pics!!
|
|
|