I got them, and installing was a POA!!!!!
I have a 2009 Ninja 250r
The right side is impossible to install unless you take off the muffler first.
After bolting in the side racks, I notice the bolt for the rack would press into my stock muffler.
The Turn signals have to be relocated to the rear fender, the instructions doesn't tell you, that you need solder or splice in longer wire!!!
If you did a fender chop, your screwed, cause you need them for the re-location of the turn signal lights!
Another thing I do not like is, there side bags will shift backwards and forwards about 5mm . To fix this I going to spray some rubber grip paint on the mount points to see if stops the sliding.
This is the 3rd Givi product I have even owned, and I was expecting issues.
It would have been better if I went to a sw-motech product, but then again they cost $$$$$$$$$
I would rate this product 6/10.
The instructions suck!!!
It cost $$$$$$ for such headaches!!!!
Update.
Sprayed on some Rubber paint on the mount points, to make it grip better. No more play
