Quote:
Originally Posted by setasai
Thanks. I did for the pulley, kinda. I'm going with something even simpler for the bracket. Looking at just a 5cm piece of 90deg aluminum angle with holes drilled into it.
|
The problem with the two armed pulley is that the cable can't wrap around the circumference of the pulley so the nut travel has to be line of sight with the bracket.
Also, the radius is critical for the same reason. Unfortunately, this means you have to grind off part of the original TB bracket so that it doesn't hit.
The distances from the top of the bracket to the cable nuts are 60 and 70mm for the respective cables. I don't see how you are going to maintain the proper geometries with a straight bracket. Maybe if you used two pieces of angle attached to a center trunk with one higher for the decel cable.