Quote:
Originally Posted by 1ER6F
Question about the mixture screws on the carb.
Before making any adjustments on the mixture screws I wanted to see where they were set at from the factory.
My stock mixture screw settings were set at 1.5 turns out on the Right and 2.5 turns out on the Left.
So, when you adjust the mixture screws to account for these newly installed mods do you need to offset the number of turns as well?
Like possible going 2.25 turns out on the Right and 2.75 turns on the Left. Thanks!
Area P full exhaust installed w/ K&N R0990 air filter, starting with 108 mains, starting with 3rd position on needle, and starting with 2.75 turns out.
|
Where'd you get the area P exhaust???
You turn the screws all the way in and then back them out to reset them. If you look at the needles when you screw them in all the way they are at different heights because they dont screw in the exact same number of turns. That is why they were offset most likely.