January 17th, 2012, 04:00 AM
|
#101
|
Blind 250 Loving Whore
Name: Tom
Location: Chesapeake, VA
Join Date: May 2011
Motorcycle(s): 2008 250R, 02 FZ1, '20 Fat Bob 114
Posts: A lot.
|
Quote:
Originally Posted by Momaru
Not to be overly crass, but if you read through the DIY that the OP made and linked in this very thread, post #27, you'll find another good answer.
It boils down to soldering (or crimping) the wiring from the shutters (both) on the projector into a single H4 male plug, to jack directly into your OEM high-beam wiring in place of the stock bulb. It's an H4 connector on the harness, NOT an H7 as the OP used; if you go that route, you have to use the adapters that sit between the OEM bulbs and the harness.
|
Yeah, I realized what was going on with everything after I posted that. I don't have to replace the plug on my harness though. Mine has the correct plug. I'm just too used to cars I guess, only 1 plug for low and 1 plug for high threw me off at first lol.
|
|
|