Quote:
Originally Posted by Bob KellyIII
I made my carb Sync tool from PVC pipe and just made 2 small containers for the oil in line to each carb just to catch the oil (just in case) those connect to a long loop to each other with the Auto transmition oil in it.... all hooked to a board about 5' long.... I hang that from the ceiling attach a line from the containers at the top to each carb's intake port and read the results on the oil level line down on the board.... it's extremally sensitive ... I used it on my XS650 yamaha and it worked great... haven't tried it on the Triumph or Ninja yet though.....
it's a simple, effective method to adjust and balance the carbs that will not allow the oil to be sucked into the engine. (as it will catch it in either container)
....
I think I posted a few pictures of it here but not sure... I know I did on the XS650.org forum.......that was about 5 years ago.
....
it really smoothes out an engine to have those carbs synced!
.....
Bob........
|
I was going to do that and I think I’m going to go back to that method