View Single Post
Old July 14th, 2009, 09:06 PM   #8
CANTFUNCTION
ninjette.org member
 
CANTFUNCTION's Avatar
 
Name: Chris
Location: Georgia
Join Date: May 2009

Motorcycle(s): 09 ninja 250(red)

Posts: 193
Quote:
Originally Posted by NJD022588 View Post
I'm about to install a jet kit on my bike and would like to use this method... but, is there any way to get the caps off of the idle mixture screws while leaving the carbs in the bike?

I'm just trying to estimate my work before I start and realize that this cant be done.
VeX used Milwaukee Offset Screwdriver to get his out check out his DIY - Accessing and adjusting idle mixture screws http://www.ninjette.org/forums/showthread.php?t=10246
CANTFUNCTION is offline   Reply With Quote