View Single Post
Old September 22nd, 2015, 05:33 PM   #6
Duckfiz
ninjette.org member
 
Duckfiz's Avatar
 
Name: Lee
Location: Murphy, NC
Join Date: Aug 2015

Motorcycle(s): '07 Ninja EX250

Posts: 17
Quote:
Originally Posted by ducatiman View Post
^ dayam....do they run as good as they look?

remember you'll need 2.5 , 3 and 4mm allen wrenches to fully service (and split) these in the distant future.

2.5 for the bowls and diaphragm caps
3 and 4 for the link bars

ty, duckfiz
And the customer service continues on......thanks for the allen wrench info. Oh, and I like the "distant future" time table.

The bike runs great! Installed the carbs on Sunday and was back on the road enjoying a run over the Cherohala. I didn't think a lil' 250 could be this much fun!

Thanks again Gordon.

BTW, I was wondering if you service all makes and models? I may be picking up some cheap older bikes for something to do over winter. It sure would be nice to send the carbs off to you while I attend to the other stuff.

Duckfiz
Duckfiz is offline   Reply With Quote