View Single Post
Old October 10th, 2013, 09:06 AM   #19
dino74
ninjette.org certified postwhore
 
dino74's Avatar
 
Name: dino
Location: Oceanside, Ca
Join Date: Nov 2010

Motorcycle(s): '09 250 Street, '09 250 Race, '13 300 Race

Posts: A lot.
Alex,

I did another set and need to add some new tips. Can you add these edits.

After "The bottom part off the cartridge is bolted to the outer fork in the same manner as the damper rod."

Use something to hold the cartridge in the center of the outer fork opening.


After "Pour the oil into the forks"

If possible, use a funnel to pour the oil directly into the cartridge tube. This make bleeding the air much much easier.


After "After the oil level is set, insert the springs, plastic preload adjuster and screw on the top cap."

Make sure the compression/rebound screw is all the way out. You don't want the needle bottom out as you are screwing on the cap.
__________________________________________________
CVMA #55
dino74 is offline   Reply With Quote


1 out of 1 members found this post helpful.