Had to make rear motor mount plates and offset spacers, complete header (y-pipe and mid-pipe), radiator mounts, etc... All kinds of stuff. All without welding to, or otherwise disturbing the 250 chassis. Used the 500 harness and 250 controls and gauges. Looks stock. Isn't. If you look at the other builds on YouTube and in other various locations, the absence of attention to detail is apparent. Using a piece of flat stock to hold the fairings apart so the exhaust doesn't touch? Are we in Junior High WoodWorking? Not trying to step on anyone's toes, but this isn't exactly an extracurricular art class. The job should be done properly or the wrenches should be put away.
Last futzed with by standard81; November 5th, 2010 at 08:30 PM.
Reason: adding info.
|