Resistance in gear
Today my bike wouldn't start, and the starter would spin the motor and then get stuck as if the engine was seized. It rolls freely without resistance in neutral, but when I put the bike into first gear it was really hard to push with the clutch in, and then after a bit of movement it loosened up and then I got the bike to start normally
This isn't the first time it's done something like this, but I just changed the oil less than 100 miles ago so it's completely fresh. It sat for a little over a week before I tried starting it today
Is this something I should be worried about?
2006 250 with about 10k on it
A side note, the carb was rebuilt recently because it was leaking fuel, and I think there may have been a lot of fuel in the oil which is why I changed the oil. the last time it did it was after sitting for almost a year with the old oil
|