[jkv45]

Originally Posted by jdnightfox

New clutch cable is now installed. Problem is still there

I set the bike in my driveway so I could roll it back and forth. With it in first gear, and not touching the clutch lever, the bike does not want to move at all, which is how it should be

However, immediately as I start pulling the clutch lever, it releases and begins to slip. This is with pulling the clutch lever about 1/4 inch and no matter how much further I pull it, it still has the same amount of slip and resistance to movement

As TJ noted - that sounds normal to me unless I'm missing something here.

Confirm you have adequate slack in the clutch cable.

Info on cable adjustment - https://faq.ninja250.org/wiki/Adjust...e_clutch_cable