|
Ok so, Emgo switch arrived and installs exactly as the original one did. Plugs right in with the stock connectors. Key Switch turns the dash on, lights come one, starter works and will turn engine over, however I am barely getting voltage at the spark plug wires when I try to start it. Volt meter goes from zero at rest to1.3- 1.5 volts when cranking. Obviously this is not enough to get her to run.
Not sure if this means the switch works and I have another problem or if the switch could somehow be causing this. Have an original 07 EX250 switch arriving today via eBay so the next test will be to switch the Ignitions and see what happens. If that doesn't work what should I check next?
|