Quote:
Originally Posted by Cobra46
I bought this bike about a month ago, 2010 Ninja 250, the guy had dropped it at one point and the front right turn signal was broke off. My new ones just came in and I figured once I hooked up the new front right signal I would be good to go. I hooked up the front right one, and both on the right side just stays solid. The left works fine as always. I even unhooked the old rear right one and hooked up a new one, still staying solid. I tried putting slight bends in the prongs on the connectors, I tried wiggling all the wires. What else can I do?.. any ideas? If it was the relay or fuse was bad then none of the turn signals would be working, correct? This is driving me nuts. Thanks.
|
Perhaps check that you have the correct wattage and type of globe in the new one. If it’s the incorrect wattage or an LED it may cause what you report to happen.