Quote:
Originally Posted by StrangeRida
hmmm weird as I have not touch any other wiring at all just wanted to change over to LED.
What do I need to do next to eliminate the problem?
Any suggestions?
I used a Voltmeter to find the +12V wire
|
You have pre-existing issue, so you need to fix that before changing to LED.
1. power-off
2. unplug both rear turn-signals
3. measure resistance to chassis-ground of each wire in each rear turn-signal harness connector (4 measurements total).
4. what are these measurements?
5. measure resistance between each terminal of each rear turn-signal harness connector
6. what are these two measurements?