ninjette.org - View Single Post

dukeswift · October 23rd, 2018, 06:33 PM

I've been working on this 96 250 for awhile and figured it was time to step up to real clip ons and controls.

I've scoured the forums and without a straight-forward guide I'm left kind of guessing here. None of those posts were solved so here goes nothing...

Ideally I would like the most simple wiring as well, but out of frustration have sufficed with just what I have.

With my current wiring I can get the bike to turn on (radiator fan starts running) but it won't crank when I push the yellow button. Battery is good, safety switches isolated, and jumped the starter and it will crank.

I ordered a new start/stop switch off Amazon to mount to the handlebar, but there's no diagram with it.

Red button wires: blue, white, green
Yellow Button wires: Brown, yellow

From the harness I have IGNITION Brown connected to Grey with a 100 ohm resistor. The White wire is connected to White/Black. I connected these to two of the three wires for the red button, which powers the bike ON when pressed. EDIT: The wire from the push button only works when connected to the brown wire, not the grey wire after the resistor, even though BROWN and GREY are connected via resistor is this an issue?

I traced the RED/BLACK wires from the stock RH control and wired these each to the yellow button's wires.

(PHOTOS)

https://drive.google.com/open?id=1K6...kU4_XHdGChBq7h
https://drive.google.com/open?id=1OM...NkHz74p_YsWAes

Maybe I'm missing something?
Please help!

Sidenote: If someone makes a simple diagram I'll do a write up AND KEEP THE PHOTOS ONLINE FOR THE COMMUNITY!

October 23rd, 2018, 06:33 PM	#4
dukeswift ninjette.org member Name: Kyle Location: Kansas city Join Date: Apr 2014 Motorcycle(s): 02 Aprilia RS70 97 Ninja 250 Posts: 53	Same idea... Just trying to get it to crank I've been working on this 96 250 for awhile and figured it was time to step up to real clip ons and controls. I've scoured the forums and without a straight-forward guide I'm left kind of guessing here. None of those posts were solved so here goes nothing... Ideally I would like the most simple wiring as well, but out of frustration have sufficed with just what I have. With my current wiring I can get the bike to turn on (radiator fan starts running) but it won't crank when I push the yellow button. Battery is good, safety switches isolated, and jumped the starter and it will crank. I ordered a new start/stop switch off Amazon to mount to the handlebar, but there's no diagram with it. Red button wires: blue, white, green Yellow Button wires: Brown, yellow From the harness I have IGNITION Brown connected to Grey with a 100 ohm resistor. The White wire is connected to White/Black. I connected these to two of the three wires for the red button, which powers the bike ON when pressed. EDIT: The wire from the push button only works when connected to the brown wire, not the grey wire after the resistor, even though BROWN and GREY are connected via resistor is this an issue? I traced the RED/BLACK wires from the stock RH control and wired these each to the yellow button's wires. (PHOTOS) https://drive.google.com/open?id=1K6...kU4_XHdGChBq7h https://drive.google.com/open?id=1OM...NkHz74p_YsWAes Maybe I'm missing something? Please help! Sidenote: If someone makes a simple diagram I'll do a write up AND KEEP THE PHOTOS ONLINE FOR THE COMMUNITY!