View Single Post
Old February 9th, 2013, 07:33 PM   #86
msebastian
ninjette.org guru
 
msebastian's Avatar
 
Name: Michael
Location: Dayton, Ohio
Join Date: Jul 2012

Motorcycle(s): 2009 Ninja 250R SE

Posts: 262
Just finished up the coolant flush and added the engine ice coolant. I got all the air bubbles out and waited for the fan to turn on. This seemed to take awhile since the new coolant is suppose to reduce temps by 50 degrees. But it is done and the bike seems to be running a tad bit better.

I found a rats nest or something in the rear compartment, and the wires were all chewed up and mangled. So I rewraped each wire individually and then rewrapped them back together. I went through some of the wires today to rearrange them because they did not seem very organized and were just hanging all over.

The tube coming off of the valve cover that was not blocked off after the Kleen air delete makes the bike much louder, but when I plug the tube the bike runs much smoother and throttle response seems much better. The block off plate will be here before or on Thursday so that will be fixed.

I will be doing some more tomorrow and for the next couple days as more parts start to come in.
msebastian is offline   Reply With Quote