Quote:
Originally Posted by trevor_shiggs
I removed my snorkel today. When snapping the throttle from around 4000 RPM it seems like its bogging and will pick up slightly as I roll off the throttle. Noticed most in fifth and sixth. I don't remember it doing this before. I have a dan moto slip on and two washers under the needles. I am thinking I need to add a third? I tried putting the snorkel back in but that was a PITA. My air filter is pretty dirty too so I will be cleaning that tomorrow. I will measure the thickness of the washers tomorrow, I need to bring my micrometer home. I was also thinking about drilling my slides while I am adding another washer. Would you say that I need to add another washer? And should I do my slides while I am in there? Thanks
|
I have the same setup essentially, except I removed 1 washer after removing the snorkel - so the needles are only shimmed with 1 washer, and I don't really notice any problems.