ninjette.org - View Single Post - Squid Repli-Racer 250 build

65Mulberry · June 18th, 2019, 07:49 AM

I'll check on That Cibie headlight! And I actually considered an undertail exhaust!! I think for now going to keep exhaust relatively stock (if I dont use my wrapped home-built 2-1...) and sort out the kinks on engine, wiring, and other cosmetics.... then go back revisit exhaust.

I ran this homemade 2-1 header on another EX250 for a while--other than the OEM single muffler getting uber hot it actually worked and sounded great. adn it was easy to jet too w/stock airbox in place. I followed the steps of the dude that's link been reposted on here a dozen times to build it.

BUT.....I really really REALLY love the look of this wrapped 2-1 header.

I will make a short bent extension of the pipe before the muffler after the 2-1 collector so the Cobra R will mount up much higher (zoom in on stock muffler mount I left intact on right side of my subframe mod...) like a hi-mount-- rather than where it is now in stock location down low.

June 18th, 2019, 07:49 AM	#13
65Mulberry ninjette.org member Name: Jon Location: Alabama Join Date: Jun 2019 Motorcycle(s): Suzuki bandit 1200 Ninja 250 Posts: 60	I'll check on That Cibie headlight! And I actually considered an undertail exhaust!! I think for now going to keep exhaust relatively stock (if I dont use my wrapped home-built 2-1...) and sort out the kinks on engine, wiring, and other cosmetics.... then go back revisit exhaust. I ran this homemade 2-1 header on another EX250 for a while--other than the OEM single muffler getting uber hot it actually worked and sounded great. adn it was easy to jet too w/stock airbox in place. I followed the steps of the dude that's link been reposted on here a dozen times to build it. BUT.....I really really REALLY love the look of this wrapped 2-1 header. I will make a short bent extension of the pipe before the muffler after the 2-1 collector so the Cobra R will mount up much higher (zoom in on stock muffler mount I left intact on right side of my subframe mod...) like a hi-mount-- rather than where it is now in stock location down low.