ninjette.org - View Single Post - DIY

Army Aviator · February 18th, 2009, 02:18 PM

I'm made this vacuum setup and was wondering, why did you guys use 1/4 ID tubing on the test rig when the fittings on the bike are only 3/16"? I had to use adapters because there was no way that was going to make a good seal.

Also, thanks for the test port idea kkim. I'm setting mine up similar to yours.

February 18th, 2009, 02:18 PM	#21
Army Aviator ninjette.org member Name: Nate Location: Alabama Join Date: Dec 2008 Motorcycle(s): Ninja 250R Posts: 28	I'm made this vacuum setup and was wondering, why did you guys use 1/4 ID tubing on the test rig when the fittings on the bike are only 3/16"? I had to use adapters because there was no way that was going to make a good seal. Also, thanks for the test port idea kkim. I'm setting mine up similar to yours.