Good morning everyone, so I was able to install the 300 motor in the 250, I did use the 300 front mount bracket, the coil o plugs, stock exhaust, stator and magneto. I did start it up but i only did so twice, it seem that i have to check valve clearance and shim them, because there is a ticking noise. I did extend about 5 wires to make this work
And my biggest problem is that clutch needs to be held down to start the bike(which has never happened before) and when i go to release the clutch the bike died, i have today off and will check to see if my sensor is working after i shim the valves
|