Quote:
Originally Posted by DannoXYZ
Make sure everything is lined up properly. You must shove both carbs on at same time. Don't try to do one at a time. When installing, make sure the clamps are completely loose, hanging on by last screw thread. Or remove clamps completely.
1. Both boots on engine fully. Tighten clamps
2. Both carbs onto boots fully. Tighten clamps
3. Shove airbox onto carbs. Some people remove the coil springs and use clamps afterwards
Helps to lube all the contact areas with some silicone grease.
|
Grease was my next idea. I usually just roll the springs all the way back on the airbox boots, and start then from the bottom.