ninjette.org - View Single Post - 2000 ZZR250-GP Race bike

Mohawk · January 10th, 2019, 08:26 AM

If I hadn't changed all the bearing & had the arm blasted & powder coated then, it would have been a 5 minute job.

Points to note;-

1. The ZZR swingarm pivot is 16mm, KR-1S is 20mm, solution, is a piece of od20/id16 stainless steel pipe cut to length to suit.

2. The KR-1S swingarm has sufficient room for 4x neddle roller bearings, but only 2 are fited as standard. I used 4 works a treat should last longer than the bike.

January 10th, 2019, 08:26 AM	#49
Mohawk ninjette.org guru Name: Chris Location: Bristol, UK Join Date: Feb 2016 Motorcycle(s): ZZR250, VFR800 Posts: 478	If I hadn't changed all the bearing & had the arm blasted & powder coated then, it would have been a 5 minute job. Points to note;- 1. The ZZR swingarm pivot is 16mm, KR-1S is 20mm, solution, is a piece of od20/id16 stainless steel pipe cut to length to suit. 2. The KR-1S swingarm has sufficient room for 4x neddle roller bearings, but only 2 are fited as standard. I used 4 works a treat should last longer than the bike.