question about shimming those needles
ok i, had installed a jet kit from the dealer last year, bike runs great, i joined the forum and lookin at the DIY's it seemed easy just a b!tch to get the needles back in especially the left one and i was fore warned. so the question is i got is after i put the washer under the needle noticed an e clip and various slots in which to move the clip up or down. i put the washer in anyway not knowing if i could move the clip instead.
the bike runs fine no choke needed at startup now. i blasted around the block and all is good should i redo it and move that clip instead of the washer??? or just leave it alone??
|