|
yes it does... but when it gets to that point there is so little weight on the blade it will stop cutting and not cut through....
so logically you'd think there is too much spring tension on the gravity feed system holding the blade up.... but it already has a huge amount of pressure on the start of the cutting ... cutting a 2" pipe it would have an insane amount of weight on the start of the cut but it decreases to nothing before it cuts through
....it's obviously designed wrong.... or i am using it wrong i don't know which ! LOL
.... I will try decreasing the spring tension to get more weight on the end of the cut... but i fear it will take teeth off the blade or just brake it
.... it seems like all the ones on youtube don't have this problem... they just decrease the gravity feed tension and to hell with the start of the cut pressure
.... so I guess that is what I'll do .... strange way to run a railroad !
....
Bob............
__________________________________________________
Its too late when you've gone too far !
|