ninjette.org - View Single Post - 2007 250ZZR Carb cleaning - any mods should I do while the carb is apart?

SibSerge · November 10th, 2019, 07:05 PM

I have finally assembled everything today and rode it a bit on the driveway. The response to the throttle is good. No lag or hesitation.

Not until I received the new parts has I realized how shot all the rubber was. The new airbox gasket is puffy and seals the box well. The old breather tube was barely staying put, the new one was hard to slide on but it stays solid.

I suspect that breather tube alone was a huge leak

My new fuel filter routing did not go well , the hose tends to kink. I will have to add a 90degre elbow.

Next stop is the synchronization and mixture screw tuning.

November 10th, 2019, 07:05 PM	#24
SibSerge ninjette.org member Name: Sergey Location: Ontario, GTA Join Date: Oct 2019 Motorcycle(s): Ninja ZZR250 (EX250H) Posts: 213	I have finally assembled everything today and rode it a bit on the driveway. The response to the throttle is good. No lag or hesitation. Not until I received the new parts has I realized how shot all the rubber was. The new airbox gasket is puffy and seals the box well. The old breather tube was barely staying put, the new one was hard to slide on but it stays solid. I suspect that breather tube alone was a huge leak My new fuel filter routing did not go well , the hose tends to kink. I will have to add a 90degre elbow. Next stop is the synchronization and mixture screw tuning.