ninjette.org - View Single Post

Bob KellyIII · August 21st, 2021, 10:28 PM

we got the jet kit and I put it in and it took me a few minutes to figure out how to get the air screw out as it was the type you bust off the end of it so no one can mess with it.... but I did finally get it out, there was about 1/2 of a thread showing on the screw so I took a sharp awl and tapped it lightly with a small hammer till i got it to turn a few times then I could grab it with the needle nose plyers and un screw it. the isle/airscrew that came in the kit was one of the same kind but I didn't brake off the end ! so it can still be adjusted.
it is a bit stronger running now, not massive but noticeable !
85 miles on it at last check, and it's still very tall for this short old man !
hahahaha !
the Ninja is more my size ! although I am wondering about lowering the rear.
.....
Bob.......

August 21st, 2021, 10:28 PM	#17
Bob KellyIII Retired motorcycle Mc. Name: Robert Location: Weed, California. Join Date: Jul 2021 Motorcycle(s): 2012 Kawasaki Ninja 250R, 2021 CSC TT250, 1977 Triumph Bonneville 750cc,2001 Honda XR650L. Posts: A lot.	we got the jet kit and I put it in and it took me a few minutes to figure out how to get the air screw out as it was the type you bust off the end of it so no one can mess with it.... but I did finally get it out, there was about 1/2 of a thread showing on the screw so I took a sharp awl and tapped it lightly with a small hammer till i got it to turn a few times then I could grab it with the needle nose plyers and un screw it. the isle/airscrew that came in the kit was one of the same kind but I didn't brake off the end ! so it can still be adjusted. it is a bit stronger running now, not massive but noticeable ! 85 miles on it at last check, and it's still very tall for this short old man ! hahahaha ! the Ninja is more my size ! although I am wondering about lowering the rear. ..... Bob....... __________________________________________________ Its too late when you've gone too far !