Thread: Jetting Woes...
View Single Post
Old September 30th, 2010, 08:18 AM   #10
tjkamper
ninjette.org certified postwhore
 
tjkamper's Avatar
 
Name: Travis
Location: Warwick, RI
Join Date: Apr 2009

Motorcycle(s): 2009 Ninja 250R

Posts: A lot.
They are deep inside a tubular housing that extends not quite as far down as the houseing for the needle jet holder and the main jet. If I remember correctly, it located left and slightly forward of the main jet which is basically right in the middle.

The tube is deep and narrow. you should be able to get it if you have the correct bit. I did not have a bit long enough for my offset screwdriver so I used a long narrow bit and a miniature set of vice-grips. IT was tight, but it can be done without removing the carbs.
__________________________________________________
Addicted to anything that has an engine and rolls.
tjkamper is offline   Reply With Quote