Quote:
Originally Posted by tjkamper
They are deep inside a tubular housing that extends not quite as far down as the houseing for the needle jet holder and the main jet. If I remember correctly, it located left and slightly forward of the main jet which is basically right in the middle.
The tube is deep and narrow. you should be able to get it if you have the correct bit. I did not have a bit long enough for my offset screwdriver so I used a long narrow bit and a miniature set of vice-grips. IT was tight, but it can be done without removing the carbs.
|
I have 3" long hex bits that fits the MOS. Hopefully it will be narrow enough.
I going to try it without removing the carbs. If need be, they are coming out.
Witht he air box gone it really isnt much more work to remove the carbs completely.