I have a 2010 250 that I'm currently building into a race bike. For some reason the bike wont start now (go figure). I tore the bike down to clean/inspect everything and now she wont crank at all.
The battery & fuses are good, there's fuel in the tank, and the ignition and on/ off switch is all on. The kickstand and clutch switches are unplugged (not sure if that is the problem, however I've started it before with those 2 switches unplugged). The ground wires to the starter and engine are connected. The bike is also in neutral. Kinda going off on a limb here and asking for help online (although I know it's very hard to diagnose over the interwebz). Don't think this bike has a tip over sensor (or from searching the manual I can't find one). When I jump the starter relay it cranks but it wont start either. Any help would be much appreciated! If nothing works I guess I'll have to just drop her off at the local shop. Thanks in advance guys!
