Ninja 250 Problems Galore
Hi Ninjette! First time posting here. I have a problem with my Ninja that I can't solve.
For the past 3 months or so, I've been trying to get my Ninja 250 running again, but I'm running into a lot of issues. I'm a complete noob when it comes to this. This was my first bike, and my first real project I've worked on. It started with what seemed to be a carb issue. I let the bike sit for about a month, and it started having trouble with its idle revs. The idle revs would swing ± 1500 rpm, so I had to leave it at high RPMs or it would stall. It would also get stuck at high RPMs when I gave it throttle, and would eventually come back down slowly. The throttle cable was working properly. So I decided to try cleaning the jets. That didn't do anything. I then tried rebuilding the carbs. However, now the bike won't even start. I ordered another carb off of ebay to try, but I accidentally cracked it being too rough with a stripped screw. I'm not sure if the crack matters too much so I tried it anyway, but same problem as my original carb.
At this point, when I try to start the bike, I can hear it trying to start, but it doesn't fully start. I hear the electrical sounds, and I hear a small thump. I put my hand over the exhaust and I can feel stuff coming out. I don't really know what I could have messed up so bad that it won't even start. Could it be the floats? I had to bend the tabs to get the height correct but I might have messed that up.
Any ideas about what I can try? At this point, I might just take it to the mechanic, but I don't really want to give up either. Thanks!
|