|
It won't go on evenly no matter how I rock it or tighten it. That cam is too raised and just won't fit right for some reason. I even tried trading the exhaust and intake cams to see if they would fit in their opposite spots, and the exhaust side once again sat perfectly, while the intake was raised.
But it turns out none of this matters because it that shaft just snapped putting on the cover. Ugh. This is why I was always afraid to work on engines. everything is delicate and nothing goes in the way it came out. I hardly put any force on it, too... Not really sure what to do at this point other than order new parts then ask a professional since I'm sure it still won't fit :/
|