August 18th, 2017, 01:10 PM
|
#40
|
ninjette.org certified postwhore
Name: Tom
Location: Northern Virginia
Join Date: Jul 2015
Motorcycle(s): 2001 Ninja 250, 2019 Harley Ultra Classic, 2001 Suzuki SV650
Posts: A lot.
MOTM - Jan '16
|
Quote:
Originally Posted by gitter
hey guys, its been a few days, finally had time to pull the harness and split it open.
Found that the black (signal wire for the tach) and the brown/black (im assuming ground for tach, gas gauge, and temp light) were worn through and touching, close to where the black wire splits into two wires ( to go to tach and left coil, respectively)
I dont want to jinx it but I'm pretty sure that was my problem. At this point do i just wrap the bare spots with tape and then wrap the harness back up?
|
To test that it fixes the problem yes. But you will eventually get problems there again. Best bet is solder and shrink wrap.
|
|
|