ninjette.org - View Single Post

dragono · January 16th, 2015, 05:24 PM

Hey guys i'm new here! I just got a 2005 Ninja 250. It starts and runs fine however the clutch will not disengage. It was working, but was really loose so I wont to adjust it and I acidentally pulled the bolt that goes down into the clutch out. (the thing the the cable actually actuates) So i did some research and decided to pull the clutch cover (shoulda had a new gasket ready) and the push rod seems like its not working correctly. I can remove it back and forth about 1/8 to 1/4 of an inch and there is no movement on the pressure plate. Even before I went to take the clutch cover off, I reinserted the clutch rod (not the push rod, never took it off) and tried to use it manually and the clutch still does not engage.

What am I doing wrong guys? Cable isnt broken, frayed, or anything like that.

January 16th, 2015, 05:24 PM	#1
dragono ninjette.org member Name: Bril Location: Virginia Join Date: Jan 2015 Motorcycle(s): Ninja 250 Posts: 26	Clutch Issues Hey guys i'm new here! I just got a 2005 Ninja 250. It starts and runs fine however the clutch will not disengage. It was working, but was really loose so I wont to adjust it and I acidentally pulled the bolt that goes down into the clutch out. (the thing the the cable actually actuates) So i did some research and decided to pull the clutch cover (shoulda had a new gasket ready) and the push rod seems like its not working correctly. I can remove it back and forth about 1/8 to 1/4 of an inch and there is no movement on the pressure plate. Even before I went to take the clutch cover off, I reinserted the clutch rod (not the push rod, never took it off) and tried to use it manually and the clutch still does not engage. What am I doing wrong guys? Cable isnt broken, frayed, or anything like that.