View Single Post
Old November 27th, 2018, 02:15 PM   #57
SecN8ure
ninjette.org member
 
Name: Mark
Location: Golden State
Join Date: Jun 2018

Motorcycle(s): 04EX250F

Posts: 12


I'll send you my carbs soon. I just need to recover funds from all the BF shopping.

Mark


Quote:
Originally Posted by ducatiman View Post
back to topic-

I've received DD's carbs already...

Findings.....an immediate, as received wet test revealed a very high float level on the RH carb (ta-da!) I suspect worn float valve tab spring and/or poor setting by someone prior, I'll see when I replace the float valves and setup.

Various vac hoses very loose at 4 points....very possible source of vac leaks when hot.

Synch was slightly off, rail orings were flat...

I think the high float level in the RH carb is the bad guy here....the reason why adjusting his rh pilot screw had no effect, and the bike ran better when the LH side was leaned (the LH side right on the edge of being high, too.)

Otherwise will come out mint, in & out. All new orings, float valves, likely vac hoses, proper setup (where I'll make corrections) , stainless buttonhead screws icing on the cake .....we shall see.
SecN8ure is offline   Reply With Quote