Been away for a while but great to see how things have progressed
The problem I have is, for whatever reason I took off the following nut (highlighted in red) :
No idea how I got it off while the caliper bracket was off the bike...but I would like to know if there is any specific torque value I need to use when putting it back on ?
(Part of the story is I found the front caliper bracket pin (43045 in that picture) was considerably bent, no idea how that was even possible...dealership were the only people to touch this bike with the previous owner....
)
I searched everywhere, nothing mentioned in the service manual...apart from
Quote:
If the caliper holder shaft is damage, replace the caliper
bracket.
|
i.e as a whole assembly, but the part's diagram says otherwise
Appreciate any help