ninjette.org - View Single Post - DIY- Removing the Kleen Air System Hoses and Plugging the Holes on a 08 250R

wayanlam · September 28th, 2009, 07:32 PM

hi Kelly,

need your advice/help.

i went through your DYI one last time after having removed the kleen air from my bike, and noticed a little difference between our bikes:

in your picture you have like a 4 way splitter i think?

did you plug the one end that went to the kleen air valve with the blue bit?

where do the other two tubes go?

on my bike when we took it apart, i had a 3 way splitter, one from the fuel tank, one to the kleen air valve, and one to the carb.

since we took out the end from the kleen air, we were left with just the fuel tank and carb, so we connected that direct:

i haven't had any problems with the bike since i did this mod, so i think its ok, but id still like to know if that's what i was supposed to do, to avoid any problems down the road because i was too lazy to ask

thanks bro~
W.

September 28th, 2009, 07:32 PM	#7
wayanlam ninjette.org certified postwhore Name: Wayan Location: Bali - Indonesia Join Date: Apr 2009 Motorcycle(s): 2014 Z250 Posts: A lot.	hi Kelly, need your advice/help. i went through your DYI one last time after having removed the kleen air from my bike, and noticed a little difference between our bikes: in your picture you have like a 4 way splitter i think? did you plug the one end that went to the kleen air valve with the blue bit? where do the other two tubes go? on my bike when we took it apart, i had a 3 way splitter, one from the fuel tank, one to the kleen air valve, and one to the carb. since we took out the end from the kleen air, we were left with just the fuel tank and carb, so we connected that direct: i haven't had any problems with the bike since i did this mod, so i think its ok, but id still like to know if that's what i was supposed to do, to avoid any problems down the road because i was too lazy to ask thanks bro~ W.