ninjette.org - View Single Post

choneofakind · May 4th, 2019, 11:55 AM

I'm not sure what your plans are, but consider the Profile BiLED 2. The threaded shaft can be removed from the the projector, making it smaller if you plan to make a plate out of ABS to replace your reflector bowl. Also, it's LED, so even though you still have to mount with a voltage regulator, it can be powered straight off the headlight circuit instead of wiring direct to the battery.
https://www.theretrofitsource.com/bi...-lens-led.html

I'm running the first version of their profile biLED projectors in my Miata and it's really impressive, even though it's not quite as good as a D2S projector. No complaints so far. The bolt pattern is the same as any of their D2S offerings.

Are you planning a projector in both sides of the housing? or one on the low beam side without out on the high beam side? (I love this asymmetric aesthetic, but not everyone shares my feelings). A single LED projector would make your wiring very easy. Wire direct to your low beam, add a splitter on the high beam; single low, dual high, done.

May 4th, 2019, 11:55 AM	#2
choneofakind ninjette.org certified postwhore Name: . Location: . Join Date: Feb 2011 Motorcycle(s): . Posts: Too much. MOTM - Feb '13, Feb '14	I'm not sure what your plans are, but consider the Profile BiLED 2. The threaded shaft can be removed from the the projector, making it smaller if you plan to make a plate out of ABS to replace your reflector bowl. Also, it's LED, so even though you still have to mount with a voltage regulator, it can be powered straight off the headlight circuit instead of wiring direct to the battery. https://www.theretrofitsource.com/bi...-lens-led.html I'm running the first version of their profile biLED projectors in my Miata and it's really impressive, even though it's not quite as good as a D2S projector. No complaints so far. The bolt pattern is the same as any of their D2S offerings. Are you planning a projector in both sides of the housing? or one on the low beam side without out on the high beam side? (I love this asymmetric aesthetic, but not everyone shares my feelings). A single LED projector would make your wiring very easy. Wire direct to your low beam, add a splitter on the high beam; single low, dual high, done.